Draft. This manual is new and still growing. If something here does not match what you see in the software, the software is right — tell us and we will fix the page.
Acoustic analysis
Where it is
Not a setup-tree node. Embedded in the application.
Controls
ANALYSIS
Frequency
- Control: value (
ValueField) - Unit: Hz
- Value modes: none (plain entry)
Run a sweep of studies at different frequencies to find a resonance — a single solve answers one frequency, not a range.
VIBRATING PART
Driven by
- Control: choice (
ComboRow) - Options: ``
Wetted face
- Control: choice (
ComboRow) - Shown when:
AcousticState.structuralSource !== ""
Max gap
- Control: value (
ValueField) - Unit: m
- Value modes: none (plain entry)
- Shown when:
AcousticState.structuralSource !== ""
Refuse the mapping if any acoustic face is further than this from the part's surface. Two meshes of the same geometry keep it at a fraction of an element; 0 disables the check.
Problems reported against this step
The application reports no problems against this step.
… marks a value the application computes at run time, so the source carries no fixed text for it.