Draft. This manual is new and still growing. If something here does not match what you see in the software, the software is right — tell us and we will fix the page.
EM boundaries
Where it is
Not a setup-tree node. Embedded in the application.
Controls
BOUNDARIES
＋ Potential
- Control: action (
ToolButton2) - Shown when:
!root.magnetic
＋ …
- Control: action (
ToolButton2)
Conditional and repeated groups
Per item in EmState.boundaries
repeated once for every entry in EmState.boundaries
Kind
- Control: choice (
ComboRow)
Remove
- Control: action (
ToolButton2)
Face
- Control: choice (
ComboRow)
Potential
- Control: value (
ValueField) - Unit: V
- Value modes: none (plain entry)
The in-app guidance depends on the case:
- Held there. Zero volts on the face that is grounded is the usual reference, and every other voltage is measured against it.
- Positive is current going into the part.
- Charge sitting on the surface, not a potential — the face finds its own voltage.
Problems reported against this step
The application reports no problems against this step.
… marks a value the application computes at run time, so the source carries no fixed text for it.